Cervical Spine Traction with Gardner Wells Tongs

Published on 16/03/2015 by admin

Filed under Orthopaedics

Last modified 16/03/2015

Print this page

This article have been viewed 8593 times

Chapter 18 Cervical Spine Traction with Gardner Wells Tongs

Overview

1. Cervical spine traction is accomplished with placement of calipers or tongs to the skull and attachment to a pulley system secured to the bed.

2. Although a wide variety of tongs exist, Gardner Wells tongs are the most frequently used and the most frequently available. Gardner Wells tongs consist of a hoop attached to two 30-degree angled pins.

Indications for use

1. Subaxial cervical fractures that are malaligned

2. Subaxial cervical facet dislocations

3. Selected odontoid fractures, hangman’s fractures, and C1-C2 rotatory subluxation

Precautions

1. Before application of cervical spine traction, consultation with the treating spine surgeon is paramount. Typically, unconscious or uncooperative patients require a magnetic resonance imaging (MRI) scan prior to reduction to rule out an associated disc herniation. Some controversy exists with regard to obtaining a prereduction MRI scan in patients who are awake and cooperative.

2. Repeat cervical spine radiography is essential. Use of a C-arm machine allows repeated radiography to evaluate the reduction as weights are added.

3. Careful pin placement is paramount to avoid iatrogenic injury.

4. Pin site entry is 1 cm above the pinna (earlobe) in line with the external auditory meatus.

5. Ensure that the pressure-sensitive spring-loaded indicator on the pin protrudes by 1 to 2 mm to indicate 30 inch/pounds of pressure.

6. The pins should be tightened simultaneously.

7. Traction weights need to be added cautiously and sequentially.

a. Start with 10 lb and add 5 lb per level. For example, a C5-C6 injury should have 35 lb of traction weight.

8. Gardner Wells tongs need to be retightened after 24 hours. However, they can only be retightened once.

9. The following complications can occur with application of Gardner Wells tongs:

a. Skull perforation

b. Injury to the temporalis muscle or temporal artery

c. Pin migration or pullout

10. No absolute maximum weight for traction exists, but some authors suggest a limit of 70 lb. Be aware that MRI-compatible tongs are made of graphite and titanium, resulting in lower failure loads. Avoid using these tongs if more than 50 lb are to be used.

Pearls

1. Prior to application, ensure that a complete neurologic examination is documented.

2. If an MRI scan is planned, ensure that the Gardner Wells tongs are made of MRI-compatible graphite tong and titanium pin system.

Buy Membership for Orthopaedics Category to continue reading. Learn more here

Related

Handbook of Splinting and Casting Mobile Medicine Series